About the product

Mould to make dumpy swivel wire sinkers
Built in flattened tail acts like a lead lift
Sink lifts off of the seabed on the retrieve
The sinker casts well
Wires help to hold on the seabed
Wires swivel to allow easier retrieval of your tackle
Available in 4oz – 5oz – 6oz – 7oz sizes
Supplied with mould formers and tube to aid grip wire bending
The use of rollers helps to secure the wires (not included)
Uses tail wires, long or short (NOT included)
Instructions included

VMO Roller Grip Quick Lift Mould -Fishing Lures Shop vmo own brand logo16

A single cavity mould which produces a dumpy sinker which features swivelling grip wires and a built in lead lift. The squat shaped sinker casts well and the flattened tail section acts like a lead lift helping to lift it clear of the seabed on the retrieve.

The mould makes indents in the side of the sinker to locate the grip wires in place whilst fishing but allowing them to swing clear when you wind in.

The mould comes complete with mould former pins to make the grip wire holes and also two pieces of tube to aid bending the wires to the correctly

The mould takes tail wires and either long or short can be used (Tail wires are NOT included)